Assessment

Continous Assessment Activities

Title	Weighting	Hours	ECTS	Learning Outcomes
Continuous assessment tests (3)	25%	25	1	CM17, SM21
Final exam	50%	2	0.08	CM17, SM21
Laboratory	25%	50	2	CM17, SM21
Make-up exam	50%	2	0.08	CM17, SM21

a) Procedure and assessment activities' plan

The assessment is continuous with specific activities (exams and assignments) throughout the course. These assessment activities generate a series of grades that determine the final grade.

The calculation of the final grade, n, follows the expression:

n = max( x·50% + c·25% + p·25%, x·75% + p·25% )

where x, c, and p are the grades of the exam, continuous assessment, and project parts, respectively.

The final grade will be, at most, a 4.5 if x or p <5. In other words, exam and project must be passed separately.

Note that, in case the continuous assessment does not improve the final grade, it is not taken into account, thus the final grade is the maximum of the grades with or without the continuous assessment.

The exam grade (x) is the grade obtained from the final exam, which is to be held on-site and which can be retaken.

Continuous assessment grade (c) is calculated from a weighted average of continuous assessment tests along the course. Typically, there will be three of these.

The grade awarded for the practical work (p) will be the result of a weighted average of the grades of the follow-up reports.

The exams (final or partial) are individual and the practices and activities and group work.

This subject does not provide for the single assessment system.

b) Assessment activities schedule

The dates of the continuous assessment tests and assignment submission deadlines will be published on the Campus Virtual (CV) and may change to adapt to eventual incidents: it will always be reported previously through the CV since it is understood that it is the usualcommunication platform between lecturers and students.

c) Re-assessment procedures

Late submissions,subject to prior notice, will be accepted and penalized with a lower grade. Late submissions without prior notice or justification of force majeurewill not beaccepted. A second submission period may be opened for reports that receive a negative evaluation.

Unaccepted or unsubmitted assignment reports will be scored 0 and will not have the option of a second assessment.

In accordance with the coordination of the Degree and the deanship of the School of Engineering, the following activities cannot be re-assessed:

- Practice work, 25% of the final grade

The continuous assessment can be made up by the final examination.

There is a make-up exam for the final examination, too.

d) Assessment review procedure

Assessment activities can be reviewed any time after corresponding grades are published and before the deadline for the revision of the final exam.

Should the change of a grade be agreed upon, that grade may not be modified in a later review.

No reviews will be done after the closure of the reviews of the final exam, but for the make-up exam.

e) Grading

A "non-assessable" grade is assigned to students that have not participated in any assessment activity. In any other case, not participating in an assessment activity scores 0 in the weighted average computation.

Honours will be awarded to those who obtain grades greater than or equal to 9.0 in each part, up to 5% of those enrolled in descending order of final grade. They may also be granted in other cases, provided that they do not exceed 5% and the final grade is equal to or greater than 9.0.

f) Irregularities, copies and plagiarism

Copies are evidences that the work or the examination has been done in part or in full without the author's intellectual contribution.This definition also includes attempts of copying in exams and reports, and violations of the norms that ensure intellectual authorship. Plagiarisms refer to the works and texts of other authors that are passed on as their own. They are a crime against intellectual property. To avoid plagiarism, quote the sources you use when writing the corresponding work reports or examinations.
In accordance with the UAB regulations, copies or plagiarisms or any attempt to alter the assessment result, for oneself of for others, like e.g. letting other copy, imply a final grade for the corresponding part (exam, continuous assessment or project) of 0 in the computation of the final score and failing the course. This does not limit the right to take action against perpetrators, both in the academic field and in the criminal.

g) Assessment of repeaters

There is no differentiated treatment for repeaters but they can take advantage of their own material from the previous year provided it is informed in the corresponding reports.